This article introduces the setting method of "Composite Code Beep Mode", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
CS9501, E950, RS-9000BT, RS-9000PT, RF5520, RF5520U
Questions
- How to set the compound code beep mode?
- Where is the compound code beep mode configuration barcode?
- How to adjust the compound code beep mode parameters?
Resolution / Answer
This setting controls the device's sound, lighting, aiming, or image-related feedback. It is usually used when you need to reduce the beep sound, confirm the scanning status, improve lighting positioning, or adjust the image reading effect.
Scan the corresponding barcode below to select the number of beeps after decoding the composite barcode.
Single beep (00h) after both parts are decoded
Scan the following barcode to a single beep (00h) will sound after both parts are decoded.
* Beep once (01h) when decoding each symbology
Scan the following barcode.* Each symbology will beep once (01h) when decoding.
Double beep (02h) after both parts are decoded
Scan the following barcode to a double beep will sound (02h) after both parts are decoded.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.