This article introduces the setting method of "Macro PDF User Prompt", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
CS9501, E950, RS-9000BT, RS-9000PT, RF5520, RF5520U
Questions
- How to set up Macro PDF user prompts?
- Where is the Macro PDF user prompt configuration barcode?
- How to adjust Macro PDF user prompt parameters?
Resolution / Answer
This article introduces the purpose and configuration method of "Macro PDF User Tips". Usually refer to this article when you need to change the default behavior of the device, adapt to the business system, or find the corresponding configuration barcode.
In this mode the decoder provides the following feedback.
Table 11-6 Macro PDF user tips
User scan content Passthrough of all symbols (beep/transmit) Transmit in any order (beep/transmit) Buffer all symbols (beep/transmit)
Last Macro PDF in Set Decode Beep / Y Decode Beep / Y Decode Beep / Y
Macro PDF in collection except last Decode beep / Y Decode beep / Y Two short lows / N
Macro PDF is not in the current collection Decoding beep / Y Two long low beeps / N Two long low beeps / N
Macro PDF format is invalid Decoding beep / Y Two long low beeps / N Two long low beeps / N
Scanned Macro PDFs in the collection Decoding beep / Y Four long low beeps / N Four long low beeps / N
Macro PDF memory exhausted N/A Three long low beeps / N Three long low beeps / N
Non-Macro PDF scanned during collection N/A Four long lows / N Four long lows / N
Clear Macro PDF Low/High / N Five long lows / N Five long lows / Y
Abort Macro PDF High Low High Low / N High Low High Low / N High Low High Low / N
Note:
- Beep only when *BEEPER_ON signal is connected.
- The "Transmit" (T) column indicates whether the symbol is transmitted to the host. N = No transmission.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.