This article introduces the setting method of "Send Configuration Code", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C740, E740, F1900, F20, K6, L3, L6BL, L3S, L6BLS, L6S, NT-2100, R3L, S3, S6, H3, M20, NT-1228BC, W6, W6-X, Z3S
Questions
- How to set up sending configuration barcode?
- Send setup code Where is the setup code?
- How to adjust the parameters for sending configuration barcodes?
Resolution / Answer
This article introduces the purpose and configuration method of "Send Setting Code". Usually refer to this article when you need to change the default behavior of the device, adapt to the business system, or find the corresponding configuration barcode.
Configuration code content may be allowed to be sent to the host. After reading the "Allow configuration barcode to upload" setting is successful, when scanning the configuration barcode, the content of the configuration barcode will be sent to the host. After reading the "Prohibit uploading configuration barcode" setting successfully, when scanning the configuration barcode, the configuration barcode content will not be sent to the host. The default is not to send the setup code.
02501
Scan the following barcode, 02501.
Allow uploading configuration codes
02500
Scan the following barcode, 02500.
Disable uploading of configuration codes*
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.