This article introduces the setting method of "Baud Rate", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C740, E740, F1900, F20, K6, L3, L6BL, L3S, L6BLS, L6S, NT-2100, R3L, S3, S6, H3, M20, NT-1228BC, W6, W6-X, Z3S
Questions
- How to set the baud rate?
- Where is the baud rate configuration barcode?
- How to adjust the baud rate parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
The baud rate is the number of bits transmitted per second in serial port data communication. The baud rate used by the module and the data receiving host must be consistent to ensure accurate data transmission. The module supports the baud rates listed below, in bit/s.
000701
Scan the following barcode, 000701.
600bps
000702
Scan the following barcode, 000702.
1200bps
000703
Scan the following barcode, 000703.
2400bps
000704
Scan the following barcode, 000704.
4800bps
000705
Scan the following barcode, 000705.
9600bps*
000706
Scan the following barcode, 000706.
19200bps
000707
Scan the following barcode, 000707.
38400bps
000708
Scan the following barcode, 000708.
57600bps
000709
Scan the following barcode, 000709.
115200bps
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.