This article introduces the setting method of "trigger decoding tone", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
CS9000, RD1900, NT-1988, NT-12895
Questions
- How to set the trigger decoding sound?
- Where is the configuration barcode that triggers the decoding sound?
- How to adjust the parameters for triggering decoding prompt sound?
Resolution / Answer
This setting controls when the device starts scanning, how long it lasts, and how continuous scans are handled. It is usually adjusted when manual triggering, automatic sensing, avoiding repeated output or improving scanning response speed are required.
After triggering the decoding switch, regardless of whether it is decoded or not, whether or not a prompt sound is emitted indicates that the switch has been triggered. Default = no beep when triggering the decoding switch.
(8410140.) *No sound when triggering decoding switch
Scan the following barcode to configure (8410140.) *There is no beep when triggering the decoding switch.
(8410141.) There is a sound when triggering the decoding switch
Scan the following barcode to configure (8410141.) and there will be a beep when the decoding switch is triggered.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.