This article introduces the setting method of "All Code Systems", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
CS9000, RD1900, NT-1988, NT-12895
Questions
- How to set all symbologies?
- Where are all the symbology configuration barcodes?
- How to adjust all coding parameters?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
Scan "All Code Systems On" to enable all symbologys; scan "All Code Systems Off" and then scan the specific symbology enable barcode to enable only specific symbologys. Note: 2D postal code will not be opened by default after all symbologys are turned on, and must be turned on separately.
(9990011.) All symbologys are enabled
Scan the following barcode (9990011.) All barcodes are enabled.
(9990010.) All symbologys are closed
Scan the following barcode to configure (9990010.) All barcodes are closed.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.