This article introduces the setting method of "check digit", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
CS9000, RD1900, NT-1988, NT-12895
Questions
- How to set check digit?
- Where is the check digit configuration barcode?
- How to adjust the check digit parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Set 1 or 2 check digits. Default = two check digits.
(3110280.) A check digit
Scan the following barcode, (3110280.) one check digit.
(3110281.) * Two check digits
Scan the following barcode, (3110281.) * two check digits.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.