This article introduces the setting method of "Send "Unread" message", which is suitable for scenarios where you need to adjust the parameters related to "Decoding Packet Format" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set send "Don't read?"
- Send "Where is the unread configuration barcode?
- Send "How to adjust parameters without reading them?"
Resolution / Answer
This article introduces the purpose and configuration method of "send "no read". This article is usually referred to when you need to change the default behavior of the device, adapt to the business system, or find the corresponding configuration barcode.
Before releasing the trigger button, if the barcode cannot be decoded within the timeout period, it is allowed to send a "not read" message (the scan engine sends characters: NR). Any possible prefix or suffix can be appended to this message.
Enable "no reading"
Scan the following barcode to enable "unread".
When this function is disabled, no message can be sent to the host even if the barcode cannot be decoded.
Disable "unread"
Scan the following barcode to disable "don't read".
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.