This article introduces the setting method of "Reread Delay Time", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
E900
Questions
- How to set the reread delay time?
- Where is the reread delay time configuration barcode?
- How to adjust the reread delay time parameter?
Resolution / Answer
This article introduces the purpose and configuration method of "reread delay time". Usually refer to this article when you need to change the default behavior of the device, adapt to the business system, or find the corresponding configuration barcode.
Used to prevent the same barcode from being read twice consecutively, the reread delay setting is the minimum time interval that allows barcodes of the same type and data to be read continuously. This delay is only used in automatic code decode mode and continuous code decode mode. The set time range is 1 to 3600000 milliseconds, and the default is 1500 milliseconds. If the reread delay time setting is greater than 3000 milliseconds, the reread delay of the setup code will be limited to 3000 milliseconds.
[Reread delay time]
Scan the following barcode to configure [Reread Delay Time].
Set the reread delay time to 1000 milliseconds, which can be set by reading the following barcodes in sequence:
- Read the "Startup Settings"
- Read the "Rereading Delay Time"
- Data code "1 issue," "0 issue," "0 issue, "0 issue (see Appendix - Data Code)
- Read "Save" (see Appendix - Save or Cancel)
- Read the "Exit Settings"
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.